ASTM A125
Load–deflection & proof loadHeat-treated helical steel springs — load and permanent-set requirements.
Springs & spring wire
Spring Testing Machine
Filter by test type, industry or standards body, or search a designation directly. Where a method has an equivalent under another body, both are shown.
ASTM A228 / A229 / A401
TensileMusic wire, oil-tempered and Cr-Si spring wire — tensile verification of spring wire.
BS 1726-1 / -2
CompressionGuide to coil springs — compression and extension spring testing.
DIN 2088 / 2089
Load–deflection & proof loadTorsion spring characteristic verification (requires torsion drive or dedicated torsion tester).
DIN 2096-1 / -2
CompressionHot-formed helical compression springs — quality requirements and load tolerances.
DIN 2097
CompressionHelical extension springs — quality requirements. Equivalent to: IS 7906 / 7907
DIN EN 15800
CompressionCylindrical helical compression springs of round wire — quality specifications (supersedes DIN 2095). Equivalent to: IS 7906 / 7907
DIN EN 16983 / 16984
CompressionDisc (Belleville) springs — load-deflection characteristic verification.
EN 10270-1 / -2 / -3
TensilePatented cold-drawn, oil-tempered and stainless spring steel wire — tensile grade verification.
EN 13906-1 / -2 / -3
Load–deflection & proof loadDesign and calculation of compression, extension and torsion springs — basis for load-test acceptance values.
IS 4454
TensileSteel wire for cold-formed springs — wire tensile strength verification. Equivalent to: EN 10270-adjacent
IS 7906
CompressionHelical compression springs — design, testing and quality requirements including load at specified length and spring rate verification.
IS 7907
CompressionHelical extension springs — load testing, initial tension and spring rate.
IS 9484
CompressionLeaf springs for automotive suspension — load rate, deflection and permanent-set testing. Equivalent to: —
JIS B 2704
CompressionJapanese Standard for helical compression and extension springs.
Showing 1–8 of 15 standards
Next
Tell us the specimen, not just the standard.
Thickness, width and expected break force decide the grip as much as the method does. Send us those and we will specify the frame, the load cell and the fixture around them.